creality_ender_2_with_some_mods
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
creality_ender_2_with_some_mods [2019/10/22 21:15] greg |
creality_ender_2_with_some_mods [2019/12/29 08:09] (current) greg |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| * The backlash nut receiving the Z rod is too far to the back (probably from irregularities in the folding process of the bracket holding it). This can be solved by bringing the Z motor back, see those thingiverse attempt to fix this common problem (https:// | * The backlash nut receiving the Z rod is too far to the back (probably from irregularities in the folding process of the bracket holding it). This can be solved by bringing the Z motor back, see those thingiverse attempt to fix this common problem (https:// | ||
| * issue : https:// | * issue : https:// | ||
| + | * Followed the solution with the 6.8k for the inductive probe (after falling in the trap he describes) https:// | ||
| ====Modifications : ==== | ====Modifications : ==== | ||
| Line 51: | Line 52: | ||
| Still cheaper than a Prusa, I have two hot ends I can swap (one for PLA, one for Nylon-CF), the Nylon-CF setup is top notch, the controler board is the best there is, I have autoleveling, | Still cheaper than a Prusa, I have two hot ends I can swap (one for PLA, one for Nylon-CF), the Nylon-CF setup is top notch, the controler board is the best there is, I have autoleveling, | ||
| + | |||
| + | ===Notes=== | ||
| + | |||
| + | Would I do it again / recommend? No, too much work. When you want to go custom I realised it is better to start from the most popular base (ie, Ender 3) and if there is a simple solution out there for your custom needs (ie, silent board from creality) choose it. | ||
| + | |||
| + | Am i happy with it? Yes, works beautifully! | ||
| ===Links=== | ===Links=== | ||
creality_ender_2_with_some_mods.txt ยท Last modified: 2019/12/29 08:09 by greg
Page Tools
